Club Car Carryall 550 2019 Maintenance And Service Manual page 69

ACCELERATOR AND BRAKE PEDAL GROUP
Figure 5-13 Accelerator Pedal Height Measurement
4.5. With park brake still locked, measure the distance from the top of accelerator pedal to floorboard. If the
measurement has changed, ratchet tooth engagement is too deep and must be adjusted.
4.6. If ratchet/pawl engagement must be adjusted, disconnect the ball joint at the top of the brake rod and rotate
the ball joint sleeve clockwise to increase engagement or counterclockwise to decrease engagement.
Reconnect ball joint (Figure 5-15, Page 5-13).
4.7. If the accelerator push rod was disconnected from the accelerator pedal, reconnect it.
4.8. Check for proper brake operation prior to driving the vehicle.
Figure 5-15 Brake Rod Adjustment
5. Adjust accelerator pedal height.
5.1. Loosen the nut and bolt (Figure 5-16, Page 5-13) securing the accelerator pedal to the pivot plate. Clamp
the accelerator pedal adjustment tool to the accelerator pedal, with the end marked accelerator pedal height
closest to the floorboard. Press the accelerator pedal until the end of the tool rests against the floorboard;
pedal height should be 5-5/8 inches (14.3 cm). Use a rubber strap to hold pedal in position against the
floorboard and then tighten nut to 26 ft·lb (35.3 N·m) (Figure 5-17, Page 5-14).
Pedal Group Adjustment – Gasoline Vehicles
1
1. Locked Position
2. Ratchet (B) Tooth Length
3. Make sure pawl (A) engages at least 75% of ratchet tooth length (B).
Figure 5-14 Ratchet/Pawl Tooth Engagement
1
1. 1/2-Inch Socket
2. 1/2-Inch Wrench
Figure 5-16 Accelerator Pedal Height Adjustment
2019 Carryall 550 Maintenance and Service Manual
2
A
3
B
2
Page 5-13
5