Bed Latch Assembly Removal; Bed Latch Assembly Installation - Club Car Carryall 550 2019 Maintenance And Service Manual

4
Tilt Bed

BED LATCH ASSEMBLY REMOVAL

NOTE: This procedure requires the aid of an assistant.
1. Park the vehicle and chock the tires.
2. Disconnect the batteries. See Disconnect the Batteries – Electric Vehicles, Section 1, Page 1-5.
3. Raise bed and secure prop rod (9) in prop rod track (2) (Figure 4-6, Page 4-13). See following WARNING.
WARNING
• Remove all cargo before raising the bed or servicing the vehicle. If the vehicle is equipped with a prop
rod, ensure that it is securely engaged while bed is raised. Do not close bed until all persons are clear
of cargo bed area. Keep hands clear of all crush areas. Do not drop cargo bed; lower gently and keep
entire body clear. Failure to heed this warning could result in severe personal injury or death.
4. Remove the four bolts (12) and lock nuts (7) that secure the bed latch (6) to the underside of the bed (Figure
4-7, Page 4-15).
5. Remove the bed latch (6) and springs (5).

BED LATCH ASSEMBLY INSTALLATION

1. Install bed latch (6) and springs (5).
NOTE: Latch assembly needs to sit open exactly as shown (Figure 4-7, Page 4-15).
2. Install the four bolts (12) and lock nuts (7) that secure the bed latch (6) to the underside of the bed. Tighten
to 70 to 80 in·lb (8 to 9 N·m).
3. Connect the batteries. See Connect the Batteries – Electric Vehicles, Section 1, Page 1-5.
4. Remove tire chocks.
Page 4-14 2019 Carryall 550 Maintenance and Service Manual
BODY AND TRIM