Table of Contents
Advertisement
BODY AND TRIM
COWL REMOVAL
1.
Park vehicle and chock tires.
2.
Disconnect the batteries. See Disconnect the Batteries – Electric Vehicles, Section 1, Page 1-5.
3.
The cowl is secured by tabs located behind the front fenders (2), and under the lip of the dash (1) (Figure 4-2,
Page 4-6).
4.
Push down and rearward on front fenders to unsnap cowl in two locations.
5.
Slide cowl forward until free, then lift out cowl.
COWL INSTALLATION
1.
Slide bottom edges of cowl into grooves in front fenders.
2.
Ensure the three tabs on cowl install under lip of dash (1) (Figure 4-2, Page 4-6).
3.
Ensure sides of cowl (3) assemble between the two ribs on side of dash.
4.
Ensure center tab on cowl assembles beneath the rib in the grille.
5.
With fenders disengaged from the front bumper, press down on front fenders, line up cowl tabs and fully engage
snap tabs.
6.
Ensure front corners of cowl are engaged with front fender (2).
7.
Engage the front fenders to the body clips under the front bumper.
NOTE: Ensure that cowl is fully engaged to prevent dislodging during use.
8.
Connect the batteries. See Connect the Batteries – Electric Vehicles, Section 1, Page 1-5.
9.
Remove tire chocks.
2019 Carryall 550 Maintenance and Service Manual
4
Front Body
Page 4-5
Advertisement
Table of Contents
Troubleshooting
