Table of Contents
Advertisement
GASOLINE VEHICLE - FUEL SYSTEM
3110C
Figure 21-11 Accelerator Cable Installation - Governor
1.2.
Snap accelerator cable into FNR/accelerator cable bracket (3).
1.3.
Push dust shield (4) onto end of cable housing.
2.
At electrical component box:
2.1.
Insert barrel fitting (5) of accelerator cable (6) into cam (7) in electrical component box (Figure 21-12,
Page 21-9).
3046C
Figure 21-12 Accelerator Cable Installation - Electrical
Component Box
2.2.
Separate jam nuts (8) on cable and place threaded end into slot of electrical component box. Tighten
the jam nuts finger-tight.
2.3.
Before tightening the jam nuts, make sure the engine RPM adjustment is correct. See Engine RPM
Adjustment.
2.4.
Install electrical component box cover and tighten screw to 18 in·lb (2.0 N·m).
3.
Connect the battery and spark plug wire.
Arm
2019 Carryall 550 Maintenance and Service Manual
Engine Control Linkages
Page 21-9
21
Advertisement
Table of Contents
Troubleshooting
