Club Car Carryall 550 2019 Maintenance And Service Manual page 71

ACCELERATOR AND BRAKE PEDAL GROUP
0 to 5°
Top View of the Electrical Component Box
3016
Figure 5-18 Accelerator Cable
CAUTION
• After accelerator rod adjustment, make sure that approximately the same number of threads are
exposed at each end of the accelerator rod.
• If the lever on the limit switch in the electrical box is bent, replace the limit switch.
• When loosening jam nuts on the accelerator rod with one end disconnected, hold the disconnected
accelerator rod with locking pliers.
• When tightening jam nuts on the accelerator rod, hold the disconnected ball joint with locking pliers.
6.3. Reconnect the accelerator rod at the accelerator pedal.
6.4. Before tightening jam nuts on accelerator rod, set park brake to first ratchet and pawl position. Press
accelerator pedal and make sure the following events occur in the exact order shown:
_
6.5. If the events above occur as they should, hold the ball joint at each end of the accelerator rod with pliers
and tighten the accelerator rod jam nut against it.
6.6. Ensure that the events occur as described in the table above. See following NOTE.
NOTE: After the pedal group and accelerator rod are adjusted, the final governed engine RPM should be set. See
Engine RPM Adjustment, Section 21, Page 21-10.
6.7. Install the electrical box cover and screw.
7. Adjust the brakes. See Brake Adjustment, Section 6, Page 6-7.
8. Connect the battery cables. See Connect the Battery- Gasoline Vehicles on page 1-4.
EVENT
Park brake release
Solenoid activation
Throttle body actuation
Pedal Group Adjustment – Gasoline Vehicles
APPROXIMATE PEDAL TRAVEL
2019 Carryall 550 Maintenance and Service Manual
2° to 4°
4° to 8°
8° to 12°
5
Page 5-15