Table of Contents
Advertisement
4
Floor Mat
FLOOR MAT
See General Warnings on page 1-1.
FLOOR MAT REMOVAL
1.
Remove the brake and accelerator pedals. See Accelerator and Brake Pedal Group, Section 5, Page 5-1.
2.
Remove the top edge of the floor mat from the overlapping flange under the dash.
3.
Lift the mat from the vehicle.
FLOOR MAT INSTALLATION
1.
Install mat into vehicle. Ensure mat is laying flat.
2.
Install top edge of the floor mat into the overlapping flange under the dash.
3.
Install the brake and accelerator pedals. See Accelerator and Brake Pedal Group, Section 5, Page 5-1.
TRAILER HITCH
See General Warnings, Section 1, Page 1-1.
TRAILER HITCH REMOVAL
1.
Remove the tailskirt. See Rear Fender and Tailskirt Removal on page 4-16.
2.
Where the hitch is mounted to frame, remove two nuts, lockwashers, flat washers, and bolts.
3.
Where the hitch is mounted to hitch brace, remove the nut, lockwasher, flat washer, and bolt.
4.
Remove hitch from vehicle.
TRAILER HITCH INSTALLATION
1.
Mount hitch to hitch brace, install nut, lockwasher, flat washer, and bolt.
2.
Install hitch to frame, install two nuts, lockwashers, flat washer, and bolts.
3.
Tighten hardware to 15 ft·lb (20.3 N·m).
4.
Install tailskirt. See Rear Fender and Tailskirt Installation, Section 4, Page 4-16.
Page 4-22
2019 Carryall 550 Maintenance and Service Manual
BODY AND TRIM
Advertisement
Table of Contents
Troubleshooting
