Installation Of Insert Asssembly To Device - Assa Abloy Corbin Russwin PED5000 D Series Installation Instructions Manual

Premium Delayed Egress
PED4000 D, PED5000 D Series Exit Device
Installation Instructions
6 Installation of Insert Assembly to Device
1. The Dip Switches are on the side of the assembly.
Ensure eight S2 Dip Switches are set for application (see Section 2) .
2. Slide insert assembly into device, making sure not to pinch or crimp wires.
3. Connect device lock assembly harness to connector J1. Place wire connectors and excess wire between insert and
P.C. board. (Figure 3, Device End View)
4. Check all connections before proceeding.
5. Proceed to device mounting (see packed instructions).
Silicone dielectric grease is applied at the factory onto J200 and J201 connectors, terminals, and wires here.
For use on exterior doors
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part without
the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
See DIP Switch settings on previous page
Figure 10
21
Exit Device
FM574 01/23