Insert And Pc Board Assembly - Assa Abloy Corbin Russwin PED5000 D Series Installation Instructions Manual

Premium Delayed Egress
PED4000 D, PED5000 D Series Exit Device
Installation Instructions
2 Insert and P.C. Board Assembly
Order Separately
1-1/8"
29mm
A07 Cam
Typical Mortise Cylinder
1000-118-A07
Cylinder and Collars
• Use standard 1-1/8" mortise cylinder
with A07 cam, no collar. Corbin
Russwin #1000-118-A02 collar is not
required.
• Use Corbin Russwin spacer 370F29 for
optional 1-1/4" long cylinder.
• Use Corbin Russwin spacer 370F31 for
optional 1-1/2" long cylinder.
Assembly steps for non-factory-keyed orders:
1. Insert cylinder through the cylinder support piece in the rail insert with keyway
horizontal and toward the closest end of the rail insert.
2. Slide arming switch activator over cylinder and onto the cylinder support piece. Notch in arming switch activator
keys over the stop feature in cylinder support.
3. Secure parts in place with cylinder nut. Be certain arming switch activator sits around flange in the cylinder
support piece to allow rotation of activator.
4. Insert circuit board assembly into rail insert over cylinder and switch activator. Ensure the fingers of the arming
switch activator straddle the switch mounted to the circuit board. Press down until it snaps into all four slots in the
rail insert.
5. Verify assembly by rotating key counter-clockwise and clockwise. Key should move freely and arming switch should
trip for both rotation directions. If key does not rotate freely, verify arming switch activator is properly seated on
cylinder support piece.
P1
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part without
the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Circuit Board Assembly
Cylinder Nut
Arming Switch Activator
P5 connector - Plug this into
the end bracket's metal tab
Figure 3
5
Indicator Light (LED)
Activator Leg
1-1/8" (29mm) Mortise
Figure 2
Cylinder 1000-118-A07
(Order seperately)
P2
P3
Lens Cover
FM574 01/23