Creating A Plant - Sungrow SG8.0RS User Manual

6 Commissioning
step 2 Register an account. Refer to
password from the distributor/installer or SUNGROW, skip this step.
step 3 Download the firmware package to the mobile device in advance. Refer to "Firmware Upa-
date". This is to avoid download failure due to poor on-site network signal.
- - End
6.4

Creating a Plant

Prerequisites:
• The account and password for logging in to iSolarCloud App have been obtained from
the distributor/installer or SUNGROW.
• The communication device is normally connected to the inverter.
• System positioning is enabled and iSolarCloud App is allowed to access location
information.
step 1 Open the App, tap
cess address.
step 2 Enter the account and password on the login interface, and tap LOGIN to log in.
step 3 Tap in the upper right corner to enter the plant creation interface.
60
"7.3 Account Registration". If you have got the account and
in the upper right corner of the interface, and select the correct ac-
figure 6-1 Select Access Address
User Manual