Putting The Outdoor Unit In Place: Precautions; Data Plate On The Indoor Module; Positioning The Indoor Unit; Selecting The Location - DeDietrich MIT-M /E Installation, User And Service Manual

5.3

Putting the outdoor unit in place: precautions

5.4

Data plate on the indoor module

Fig.11
5.5

Positioning the indoor unit

7756241 - v02 - 19062020
Caution
The models concerned are as follows:
MONO AWHP 11 MR
Remove the compressor's transport supports.
Failure to perform this operation may result in an increase in the
appliance's operating noise.
See
Outdoor unit manual
The data plates identify the product and provide the following important
information.
The data plates must be accessible at all times.
MW-1001195-1
5.5.1

Selecting the location

Caution
The indoor unit must be installed in a frost-free location.
1. Decide on the ideal location, bearing in mind the space the indoor unit
requires, as well as any legal requirements.
2. Install the indoor unit as close as possible to the draw-off points in
order to minimise energy losses through the pipes.
5 Installation
MIT-M 21