Mode Select Command; Reporting Of Cleaning Mode; Diagnostic Software - Quantum P2000 Series User Manual

Mode Select
3
Command

Reporting of Cleaning Mode

Diagnostic
3
Software
To change the automatic cleaning mode using the Mode Select
command set the Vendor Unique Page (20h) byte 2, bit 1 (AC) to:
One - enable automatic cleaning
•
Zero - disable automatic cleaning
•
To save the automatic drive cleaning mode setting in NVRAM set
the Mode Select command Save Page (SP) bit to one.
When the automatic drive cleaning mode setting is saved in
NVRAM, neither a SCSI bus reset or a power cycle of the P3000
will change the mode setting.
The current drive cleaning mode can be reported by:

Diagnostic Software

•
A Mode Sense command
•
To display the current drive cleaning mode from diagnostic
software select:
•
Config/Report Clean Tape
The diagnostic screen will display:
The current cleaning mode
•
The bar code label of each cleaning cartridge
•
The number of uses of each cleaning cartridge
•
The "home" storage element of each cleaning cartridge
•
The "current" storage element of each cleaning cartridge
•
ATL P2000 Series Automated Tape Library User's Guide
Appendix C Automatic Drive Cleaning
Reporting of Cleaning Mode
3
97