Table of Contents
Advertisement
Appendix B Relocating the Library
Checking the New Installation Site
Checking the New Installation Site
Preparing the Library for Relocation
Removing Tape
2
Cartridges
82
Check the new installation site for the library using the guidelines
found in the ATL P2000/P3000/P6000 Pre-Installation Site Survey
Instructions . Make sure the new location meets all applicable
clearance, environmental, and power requirements.
You will need the following tools to prepare the library for
relocation:
# 2 Phillips head screwdriver
•
3/16-inch Allen wrench
•
Take the following steps to prepare the library for relocation:
Removing tape cartridges
•
Installing internal packing materials
•
Disconnecting library cables
•
Caution: Always prepare the library for relocation before any
move.
To remove tape cartridges:
Unload all tape cartridges from the tape drives.
1
Stop all library operation.
2
Press the Standby button on the GUI. This places the library
a
off-line after the completion of any currently executing
operations. When the library is off-line, the GUI system
state display indicates "System Off-line."
ATL P2000 Series Automated Tape Library User's Guide
2
2
Advertisement
Table of Contents
