Table of Contents
Advertisement
Chapter 5 Multi-Unit Commands
Calibrating the Libraries in a Multi-Unit Configuration
Figure 42 Configure
Multi-Unit
Calibrating the Libraries in a Multi-Unit Configuration
70
ATL
P R O D U C T S
System
Configure: Multi-Unit
Off-line
Library Unit:
Standby
Library Unit #:
Load Port
# of Libraries:
LUN Config:
O
Stop
Press the Select button until the desired option is highlighted.
2
Using the arrow buttons, scroll through the available values for
3
the desired option.
When the desired value is displayed, press the Select button to
4
advance to the next option.
When you have finished making changes to the multi-unit
5
configuration options, press the Change button to save the
options and complete the configuration.
The Calibrate All PTMs command enables you to calibrate all pass
through mechanisms in all of the libraries in the multi-unit
configuration. Calibrate the libraries during the initial installation
and after any maintenance procedure.
To calibrate all library PTMs:
From the Master library in the multi-unit configuration, press
1
the Multi-Unit tab.
ATL P2000 Series Automated Tape Library User's Guide
Back
Forward
Tapes
Service
SINGLE
SINGLE LUN
Home
Multi
Unit
Select
Change
5
Advertisement
Table of Contents
