Table of Contents
Advertisement
5
Press the SELECT button to have the drive perform its Power On Self Test.
When the drive successfully finishes running its POST, the following will appear on the LCD:
5
Press SELECT to return to DRV POST.
5
If the drive POST fails, an appropriate error message will appear. Refer to the Drive Error Code table later in this chapter for a
detailed description of the drive error codes.
FastStor LTO Error Messages
If, during operation of your FastStor LTO an error occurs, the FastStor LTO will halt the current operation and an error message
will be displayed on the LCD. In all cases, after removing the cause of the problem, cycle power on your FastStor LTO and try the
last operation again.
Error Message Listing
A description of each of the FastStor LTO error messages is provided in the following table:
Error Name
Description
SERIAL RCV
Interprocessor communication error
SRC EMPTY *
The source location is empty
dEST FULL *
The destination location is full
CPU RX ERR
The motion CPU is not ready to receive
CPU TX ERR
The motion CPU is not ready to transmit
PWR SWITCH
The front power switch was pressed
HALT
The motion CPU has been halted by a low ACT line
CAM LIMIT
A cam limit has been reached w/o tripping a sensor
INV MOV OP *
An invalid move operation occurred
REAR TAPE
A rear tape sensor was not tripped
FRONT TAPE
A front tape sensor was not tripped
REAR SLOT
A rear slot sensor was not tripped
FRONT SLOT
A front slot sensor was not tripped
PCKR FULL *
The media picker was full
* These errors will not appear on the LCD if the error occurred during SCSI interaction.
Error Name
PCKR EMPTY *
SLOT FULL *
NVM SELECT
NVM WRITE
dRIVE EJCT
dRIVE UNLd *
dRIVE HNdL
dRIVE BUSY
dRIVE dOOR
dRIVE FULL *
CT FAILED
dRIVE POST
RObOT POST
Description
The media picker was empty
There was medium in slot
NVRAM selection failure
NVRAM write failure
Drive failed to eject medium
Drive not logically unloaded
Drive 'Operate Handle' timeout
Drive busy, cannot unload tape
Drive door stepper motor limit
The drive was full
Cleaning tape failed to clean drive
Drive failed its POST
Robotics failed its POST
Troubleshooting and Diagnostics
51
Advertisement
Table of Contents
