Faststor Error Messages; Error Message Listing - ADIC FastStor FastStor Mass Storage Device Installation And Operating Manual

FastStor Error Messages

If, during operation of your FastStor an error occurs, the FastStor will halt the current operation and an error message will be
displayed on the LCD. In all cases, after removing the cause of the problem, cycle power on your FastStor and try the last operation
again.

Error Message Listing

A description of each of the FastStor error messages is provided in the following table:
Error Name Description
SERIAL RCV
Interprocessor communication error
SRC EMPTY * The source location is empty
dEST FULL *
The destination location is full
CPU RX ERR
The motion CPU is not ready to receive
CPU TX ERR The motion CPU is not ready to transmit
SLOT EMPTY No slot beam was detected
PWR SWITCH
The front power switch was pressed
HALT The motion CPU has been halted by a low ACT line
CAM LIMIT A cam limit has been reached w/o tripping a sensor
JAW SENSOR A jaw sensor was tripped
INV MOV OP *
An invalid move operation occurred
REAR TAPE A rear tape sensor was not tripped
FRONT TAPE A front tape sensor was not tripped
REAR SLOT
A rear slot sensor was not tripped
FRONT SLOT A front slot sensor was not tripped
PCKR FULL * The media picker was full
* These errors will not appear on the LCD if the error occurred during SCSI interaction.
During the FastStor POST, if the CT FAILEd, dRIVE bUSY, dRIVE dOOR, dRIVE EJCT, dRIVE HNdL, dRIVE LOAd, dRIVE PGRM, or
dRIVE UNLd error occurs, dRIVE POST will appear on the Operators Panel LCD. All other errors occurring during FastStor POST
will result in RObOT POST being displayed.
48 Troubleshooting and Diagnostics
Error Name Description
PCKR EMPTY *
The media picker was empty
SLOT FULL * There was medium in slot
NVM SELECT
NVRAM selection failure
NVM WRITE
NVRAM write failure
dRIVE EJCT Drive failed to eject medium
dRIVE LOAd Unable to load medium into drive
dRIVE UNLd *
Drive not logically unloaded
dRIVE HNdL Drive 'Operate Handle' timeout
dRIVE BUSY Drive busy, cannot unload tape
dRIVE PGRM Attempt to set drive parameters failed
dRIVE dOOR
Drive door stepper motor limit
dRIVE FULL * The drive was full
CT FAILED Cleaning tape failed to clean drive
dRIVE POST
Drive failed its POST
RObOT POST Robotics failed its POST
Note