Connecting More than One FastStor LTO
If you are connecting more than one FastStor LTO on the same SCSI channel, simply connect each unit to the previous unit with an
additional shielded interface cable. You may use either SCSI connector on the rear of on each of your FastStor LTO units.
Make sure that you configure each FastStor LTO unit with a unique drive SCSI ID and loader ID. Your FastStor LTO units will not
function properly if they have the same SCSI IDs.
Preparing the Host Computer System
Installing the Application Software
At this point you need to refer to your software installation guide for instructions on installing the backup/controlling software for
the FastStor LTO onto the host computer.
12
Hardware Installation