Table of Contents
Advertisement
Figure 77. Set the network parameters of the Oscilloscope Software.
Set the network parameters of the oscilloscope. Since the
oscilloscope cannot support obtaining an IP address automatically, you
should assign a static IP address. In the oscilloscope, press the Utility
button and press H1 button, turn the M knob to select the LAN Set;
press the H2 button, the set menu is displayed on the right. Set the
IP and the Port to the same value as the "Ports-settings" in the
software in step (3). Press the H3 button to select "Save set", it
prompts "reset to update the config". After resetting the oscilloscope,
if you can get data normally in the oscilloscope software, the
connection is successful.
Figure 78. Set the network parameters of the oscilloscope.
80
Page
June 2017
Advertisement
Table of Contents
