Table of Contents
Advertisement
8 MAINTENANCE
8.1
Instructions for returning by mail
Instruments returned for repair or calibration, either within or out of the
warranty period, should be sent with the following information: Name of the
Company, name of the contact person, address, telephone number, receipt (in
the case of coverage under warranty) and a description of the problem or the
service required.
8.2
General Care
Do not store or leave the instrument where the liquid crystal display will be
exposed to direct sunlight for long periods of time.
CAUTION:
To avoid any damage to the instrument or probe, do not exposed it to
any sprays, liquids, or solvents.
8.3
Cleaning
Inspect the instrument and probes as often as operating conditions require.
To clean the instrument exterior, perform the following steps:
Wipe the dust from the instrument and probe surface with a soft cloth.
Do not make any scuffing on the transparent LCD protection screen
when clean the LCD screen.
Disconnect power before cleaning your Oscilloscope. Clean the
instrument with a wet soft cloth not dripping water. It is recommended
to scrub with soft detergent or fresh water. To avoid damage to the
instrument or probe, do not use any corrosive chemical cleaning
agent.
WARNING:
Before power on again for operation, it is required to confirm that the
instrument has already been dried completely, avoiding any electrical
short circuit or bodily injury resulting form the moisture.
98
Page
June 2017
Advertisement
Table of Contents
