Promax OD-610 User Manual page 70

Output
►
Press the Utility button and turn the M to select the Output to go to the
following menu.
The description of Output menu is shown as the follows:
Function
Menu
Type
LAN Set
►
Using the LAN port, the oscilloscope can be connected with a computer
directly, or through the router to connect. The network parameters can be
set in the menu below.
Press the Utility button and turn the M knob to select the LAN Set to go to
the following menu.
The description of LAN Set menu is shown as the follows:
Function
Setting
Menu
Netgate
Set
Phy addr
Net mask
Save set Save the current settings and prompt "reset to update the config"
June 2017
Figure 62. Output menu
Setting Description
Trig level Output trig signal synchronously
Pass/fail Output High Level when Pass , and Low Level when Fail
Figure 63. LAN Set menu.
Press F1 button to switch between each byte, turn the M
IP
knob to change value (0~255)
Port Turn the M knob to change value (0~4000)
Press F3 button to switch between each byte, turn the M
knob to change value (0~255)
Press F4 button to switch between each byte, turn the M
knob to change value (0~FF)
Press F5 button to switch between each byte, turn the M
knob to change value (0~255)
Description
65
Page