Promax OD-610 User Manual page 2

SAFETY RULES
* The safety can turn compromised if there are not applied the instructions
given in this Manual.
* Use the equipment only on systems or devices to measure the negative connected
to ground potential or off-grid.
* This is a class I equipment, for safety reasons plug it to a supply line with the
corresponding ground terminal.
* This equipment can be used in Over-Voltage Category II installations and
Pollution Degree 1 environments (see 2.3.-).
* When using some of the following accessories use only the specified ones to
ensure safety:
Power cord
Probes
* Observe all specified ratings both of supply and measurement.
* Remember that voltages higher than 70V DC or 33V AC rms are dangerous.
* Use this instrument under the specified environmental conditions.
* The user is only authorized to carry out the following maintenance operations:
Replace the mains fuse of the specified type and value.
On the Maintenance paragraph the proper instructions are given.
Any other change on the equipment should be carried out by qualified
personnel.
* The negative of measure is at ground potential.
* Do not obstruct the ventilation system.
* Follow the cleaning instructions described in the Maintenance paragraph.
June 2017