Communication With Pc; How To Connect With A Computer Directly - Promax OD-610 User Manual

4 COMMUNICATION WITH PC

4.1 LAN operation
4.1.1

How to connect with a computer directly

Connection. Plug in the LAN line to the LAN port in the right side
panel of the oscilloscope; plug the other end into the LAN interface of
the computer.
Set the network parameters of the computer. Adjust or write
down the network settings of your PC to use as a reference to set
network parameters on the software oscilloscope and the oscilloscope
itself. Here we set the IP address to 192.168.1.71.
Figure 76. Set the network parameters of the computer.
Set the network parameters of the Oscilloscope Software. Run
the software on the computer, choose the "Ports-settings" of the
"Communications" menu item. Set "Connect using" to LAN. About the
IP, the first three bytes is same as the IP in the step (2), the last byte
should be different. Here, we set it to 192.168.1.72. The range of the
port value is 0～4000, but the port which under 2000 is always be
used, so it is suggested to set it to the value above 2000. Here, we set
it to 3000.
June 2017
79
Page