Promax OD-610 User Manual page 46

Slope trigger menu list:
Menu
Single
Mode
Source
When
Threshold
&
SlewRate
Mode
Holdoff
Pulse Width Trigger
►
Pulse trigger occurs according to the width of pulse. The abnormal signals
can be detected through setting up the pulse width condition.
The Pulse Width Trigger Menu is shown as Figure 36.
June 2017
Settings
Slope Set vertical channel trigger type as slope trigger.
CH1 Select CH1 as the trigger source.
CH2 Select CH2 as the trigger source.
slope
Slope selecting
Set slope condition; turn the M knob to set slope
time.
High level Adjust M knob to set the High level upper limit.
Low level Adjust M knob to set Low level lower limit.
Slew rate Slew rate=( High level- Low level)/ Settings.
Auto Acquire waveform even no trigger occurred.
Normal Acquire waveform when trigger occurred.
Single When trigger occurs, acquire one waveform then
stop.
Holdoff 100ns~10s, turn the M knob to set time interval
before another trigger occur.
Reset Set Holdoff time as 100ns.
Figure 36. Pulse Width Trigger menu.
Instruction
41
Page