Promax OD-610 User Manual page 78

The description of the cursor measurement menu is shown as the following table:
Function
Menu
Type
Source
When carrying out the cursor measurement, the position of Cursor 1 can be
adjusted with the VERTICAL POSITION knob of Channel 1, and that of Cursor 2
can be adjusted with the VERTICAL POSITION knob of Channel 2.
Perform the following operation steps for the Vamp cursor measurement:
Press Cursor and recall the Cursor Measure menu.
Press the H1 button, the Type menu will display at the right of the
screen. Press the F2 button to select Vamp for Type, with two purple
dotted lines displayed along the horizontal direction of the screen
indicating Cursor1 and Cursor2.
According to the measured waveform, adjust the positions of Cursor1
and Cursor2 by turning the VERTICAL POSITION knob of CH1 and
CH2. Cursor increment window at the left bottom shows absolute
value of the two cursors amplitude difference and the present position.
June 2017
Setting
OFF Switch off the cursor measurement.
Vamp Display the Vamp measurement cursor and menu.
Freq Display the Freq measurement cursor and menu.
Math FFT Display the channel for the cursor measure.
Figure 72. Wave of Vamp cursor measurement.
Description
73
Page