Select Vertical Printing (For Hanzi Big5 Printer Only); Select Vertical Tab Channel; Set 0-Dot Intercharacter Spacing Of Dbcs Characters - Printronix P7000 H-Series Programmer's Reference Manual

Chapter 3
Configuring The LQ-1600K Emulation With Control Codes

Select Vertical Printing (for Hanzi BIG5 Printer only)

ASCII Code SSCC + n
Hex Code
Dec Code
Purpose
Comment
NOTE: This command is only supported in the Hanzi TW printer.

Select Vertical Tab Channel

ASCII Code ESC / c
Hex Code
Dec Code
Purpose
Comment

Set 0-dot Intercharacter Spacing of DBCS Characters

ASCII Code SUB
Hex Code
Dec Code
Purpose
Comment
94
SSCC 2B n
SSCC 43 n
The character is printed with different degrees of rotation in the
counter-clockwise direction under DBCS mode.
n = 0 or 48
90 degrees rotation
n = 1 or 49 180 degree rotation
n = 2 or 50 270 degree rotation
n = 3 or 51 rotate DBCS full width character 90 degrees
n = 4 or 52 normal character
Where:
n = 0, 1, 2, 3, 4, 48, 49, 50, 51, 52
The default value is n = 4, normal character.
1B 2F c
27 47 c
Selects a vertical tab channel set by ESC b.
Where:
c = 0 through 7
Subsequent VT (hex 0B) commands use tab table specified by
c. If no tab table is selected, table 0 is used.
Q
1A 51
26 81
Sets 0-dot intercharacter spacing of DBCS characters.
This command affects the front panel setting of "DBCS CPI."