Select Super/Subscript Printing (For Hanzi Big5 Printer Only); Select Typeface (For Hanzi Big5 Printer Only); Select Underline Printing (For Hanzi Big5 Printer Only) - Printronix P7000 H-Series Programmer's Reference Manual

Select Super/Subscript Printing (For Hanzi BIG5 Printer only)

Select Super/Subscript Printing
(For Hanzi BIG5 Printer only)
~
n
ASCII Code SSCC
Hex Code SSCC 7E n
Dec Code SSCC 126 n
Purpose Prints characters that follow at about 1/2 their normal width and
1/2 their normal height; the printing location depends on the
value of n as follows:
n = 0 or 48
n = 1 or 49
n = 2 or 50
Where:
n = 0, 1, 2, 48, 49, 50
Comment Setting n =2 returns the character back to its normal height.

Select Typeface (For Hanzi BIG5 Printer only)

ASCII Code ESC k n
1B 6B n
Hex Code
Dec Code 27 107 n
Purpose This is to select DBCS ASCII typeface:
n = 0 Normal
n = 5 OCRB
Where:
n = 0, 5
Comment This command only takes effect in DCBS mode.

Select Underline Printing (For Hanzi Big5 Printer Only)

ASCII Code ASSC 0
Hex Code ASSC 30 54 2D
Dec Code ASSC 48 84 45
Purpose To set underline printing.
Where:
n = 0x30: reset (default)
n = 0x31: underline for all characters
n = 0x32: underline for all characters except space (0x20).
Comment This control code does not function while in non-DBCS mode.
Upper part of the character space
Lower part of the character space
Normal character
T - n
n
n
93