Select Autowrap Mode (For Hanzi Big5 Printer Only); Select Bit Image - Printronix P7000 H-Series Programmer's Reference Manual

Select Autowrap Mode (For Hanzi Big5 Printer Only)

Select Autowrap Mode (For Hanzi Big5 Printer Only)
ASCII Code ASSC 0
Hex Code ASSC 30 54 6D
Dec Code ASSC 48 84 109 n
Purpose To set Auto Line Feed
Where
n = 0x30: reset auto LF (default)
n = 0x31: set auto LF
Comment This control code does not function while in non-DBCS mode.

Select Bit Image

ASCII Code SSCC *
SSCC 2A m nL
Hex Code
Dec Code SSCC 42 m nL
Purpose Prints dot graphics in 12- or 16-dot columns, depending on the
following parameters:
Where:
0 < = nL < = 255
0 < = nH < = 31
m = 30, 31, 32
m specifies the dot density.
nL nH specifies the total number of columns of graphics data
that follow (number of dot columns) = ( nH x 256 + nL )
d1...dk bytes of graphics data; k is determined by multiplying
the total number of columns times the number of bytes required
for each column.
Parameter Horizontal
m in ESC * Density (dpi)
30 90
31 120
32 90
T m n
n
m nL nH d1...dk
nH d1...dk
nH d1...dk
Vertical
Density (dpi)
90
120
90
Dots per Bytes per
Column Column
12 2
16 2
16 2
87