Chapter
3
Configuring The LQ-1600K Emulation With Control Codes
Unidirectional Printing For One Line
ASCII Code ESC <
Hex Code
Dec Code
Purpose
Unidirectional Printing, Set/Reset
ASCII Code ESC U n
Hex Code
Dec Code
Purpose
Comment
Vertical and Horizontal Extension
ASCII Code ESC
Hex Code
Dec Code
Purpose
Comment
112
1B 3C
27 60
Causes printing to occur from left to right for one line only.
1B 55 n
27 85 n
Causes printing to occur in only one direction of shuttle
movement (left to right).
Where:
n = NUL (hex 00) or 0 (hex 30) turns unidirectional mode off
n = SOH (hex 01) or 1 (hex 31) turns unidirectional mode on
Printing normally occurs in both directions of shuttle movement.
Unidirectional printing slows the printer down approximately
50%, but it is sometimes used when very accurate dot
placement is desired in graphics.
e
n1 n2
1A
65 n1 n2
27
101 n1 n2
Enables the extension of the character bitmap so that they
touch in both horizontal and vertical directions as follows:
•
n1 = 1 or 49, n2 = 1 or 49 Normal character
•
2 < = n1 < = 4 or 50 < = n1 < = 52, n2 = 1 or 49 Double height
character (same with FS ! 8)
•
n1 = 1 or 49, 2 < = n2 < = 4 or 50 < = n2 < = 52 Double width
character (same with FS ! 4)
•
2 < = n1 < = 4 or 50 < = n1 < = 52, 2 < = n2 < = 4 or 50 <= n2
< = 52 Double width and double height character (same
with FS ! 12)
Where:
1 < = n1 < = 4 or 49 < = n1 < = 52
1 < = n2 < = 4 or 49 < = n2 < = 52
The default is normal character.