Saving Your New Configuration - Printronix P7000 H-Series Programmer's Reference Manual

Saving Your New Configuration

CONFIG.
CONTROL
Load Config. Save Config.
1
2
3
4
5
6
7
8
Name
Configs.
After changing all of the necessary parameters, you should save them as a
configuration that can be stored for future use and loaded later. If you do not
save your configuration before you power off the printer, all of your parameter
changes will be erased. The Save Config. option allows you to save up to
eight configurations to meet different print job requirements. Configurations 1
through 8 are empty until you save values to them using the Save Config.
option. For example:
Config 1: Selects Normal typeface, 6.7 cpi, 6 lpi
Config 2: Selects Near LQ typeface, 6 cpi, 8 lpi
Once you have saved a configuration using this option, it will not be lost if you
power off the printer. You can load a configuration for a specific print job and
also modify and resave it. You may want to print your configurations and store
them in a safe place, such as inside the printer cabinet.
NOTE: The Protect Configs. parameter must be set to disable before you
Print Config. Delete Config.
Reset Cfg.
Names
may save a configuration. Once you save a configuration, the Protect
Configs. parameter automatically returns to enable. Once you change
active emulations, any changes to the previously selected emulation
will be gone unless they have been saved.
Saving Your New Configuration
* = Factory Default
Protect
Power-Up
Configs.
Config.
19