Turn On/Off Ocrb Printing; Underline - Printronix P7000 H-Series Programmer's Reference Manual

Turn On/Off OCRB Printing

ASCII Code ASSC 0
Hex Code ASSC 30 7A n
ASSC 48 122 n
Dec Code
Where:
n = 0, 1, 48, 49
The default is n = 0.
Purpose Turn on/off OCRB mode as follows:
n = 0 or 48 - turns off OCRB mode
n = 1 or 49 - turns on OCRB mode
NOTE: When OCRB is turned on, the OCRB character can be printed out.
Comment This command affects the front panel setting of "OCBR
Selection."
This command only works in DBCS mode.

Underline

ASCII Code ESC – n
Hex Code 1B 2D n
Dec Code 27 45 n
Purpose Turns automatic underlining on and off.
Where:
n = NUL (hex 00) or 0 (hex 30) to turn off underlining
n = SOH (hex 01) or 1 (hex 31) to turn on underlining
Comment Spaces are underlined, but graphics and grey scale characters
are not. This control code does not function while in DBCS
mode.
Example The following program illustrates underlining.
Turn On/Off OCRB Printing
z n
111