Set Logical Left Margin (For Hanzi Big5 Printer Only); Set Margin (Left) - Printronix P7000 H-Series Programmer's Reference Manual

Chapter 3
Configuring The LQ-1600K Emulation With Control Codes

Set Logical Left Margin (For Hanzi Big5 Printer Only)

ASCII Code ASSC 0
Hex Code
Dec Code
Purpose
Comment

Set Margin (Left)

ASCII Code ESC l n
Hex Code
Dec Code
Purpose
Comment
104
T $ n1 n2 n3 n4
ASSC 30 54 24 n1 n2 n3 n4
ASSC 48 84 36 n1 n2 n3 n4
To set left margin by current left margin +n1n2n3n4. n1n2n3n4
is dot by 300 dpi, and will be converted in dot by 180 dpi.
Where:
n1, n2, n3, n4 = 0x30 ~ 0x39
This control code does not function while in non-DBCS mode.
This will affect the Left Margin front panel setting.
1B 6C n
27 108 n
Where:
n = 1 though 255; the number of columns from the left edge of
the physical page to the beginning of the print line.
Sets the left margin to n columns in the current font.
Be sure to use the alphabetic lowercase "l" (as in "left") rather
than the capital letter "I" (as in "Island") for this command. The
number of inches of margin does not vary if the font, character
width, or horizontal dot density changes. The smallest possible
space between the left and right margins is the width of one
double-wide, 10 cpi character. If a margin control code violates
this minimum distance, it is ignored. Settings in proportional
mode are treated as 10 CPI.
In DBCS mode, the right margin will be set according to the
width of DBCS characters.
This command affects the front panel setting of "Left Margin."