Set Relative Horizontal Print Position In 1/120 Inches; Set Right Margin (For Hanzi Big5 Printer Only) - Printronix P7000 H-Series Programmer's Reference Manual

Chapter 3
Configuring The LQ-1600K Emulation With Control Codes

Set Relative Horizontal Print Position In 1/120 Inches

ASCII Code ESC \ n1 n2
Hex Code
Dec Code
Purpose
Comment

Set Right Margin (For Hanzi Big5 Printer Only)

ASCII Code ASSC 0
Hex Code
Dec Code
Purpose
Comment
106
1B 5C n1 n2
27 92 n1 n2
Moves the simulated print head to a relative horizontal print
position (in dots), using 1/120 inch increments in Near LQ
mode and 1/180 inch increments in all other modes.
Where:
n1 = 0 through 127
n2 = 0 through 255
Adds ( n1 + ( n2 x 256)) dots to the horizontal position of the
simulated print head. The number sent is two's complement,
with negative numbers moving to the left. The command is
ignored if it would move the simulated print head beyond the
page margins.
T Q n1 n2 n3
ASSC 30 54 51 n1 n2 n3
ASSC 48 84 81 n1 n2 n3
To set margin in 1/10 inches (10 CPI equivalent) according to
the number of half-width characters.
Where
n1, n2, n3 = 0x30 ~ 0x39
This control code does not function while in non-DBCS mode.