Selects The Printing Type Style. (Ibm 2381 + Only) - Printronix S828 Programmer's Manual

Programmer Manual
ESC[@

Selects the printing type style. (IBM 2381 + only)

ASCII Code
Hexadecimal Value
Decimal Value
(*) These values are constants.
This command is used to modify the type style of the character and the number of line spacing. Use this
command for:
1. Italic printing
2. Single-high character
3. Double-high character
4. Single-wide character
5. Double-wide character
6. Single Line Feed
7. Double Line Feed
These selections may be combined, for example, italic print with double height or doublewide character
and double line feed.
See the following tables for m1, m3 and m4 selections:
m1 Selection
0 No Change
1 Start Italic Printing
2 Stop Italic Printing
4 Start Outline
8 Stop Outline
16 Start Shadow
32 Stop Shadow
ESC[@
Sets double high printing and double line feed. (IBM)
ASCII Code
Hexadecimal Value
Decimal Value
l= normally 4, h= normally 0, m1 =0, m2 =0
This command sets height, width, and vertical spacing.
The land hparameters specify the number of mode bytes mx contained in the sequence.
The m3 and m4 parameters specify the printing characteristics.
Chapter 1 EPSON/IBM Commands
ESC [ @ 40m1 0m3 m4
X'1B' X'5B' X'40' 04*00*m1 00*m3 m4
27 91 64 40m1 0m3 m4
m3 Selection
0 No Change
1 Single-High Character
2 Double-High Character
4 Single Line Feed
8 Double Line Feed
16
32
ESC [ @ lhm1 m2 m3 m4
X'1B' X'5B' X'40' lhm1 m2 m3 m4
27 91 64 lhm1 m2 m3 m4
m4
0
1
2
4
8
32
PTX‐S828
Selection
No Change
Single-Wide Character
Double-Wide Character
Single Line Feed
Double Line Feed
260071‐001A