Ssen -- Enable Or Disable Screen Saver; Ssstart -- Set Idle Time Required For Screen Saver To Start - Polycom Vortex EF2210 Program Manual

Q01SSDELAY>500
Q01SSDELAY?

8.110. SSEN -- Enable or Disable Screen Saver

This command controls whether or not the LCD screen saver is enabled.
This command is a boolean command. See
command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Q01SSEN1 Enable screen saver.
Q01SSEN0 Disable screen saver.
Q01SSEN2 Toggle screen saver enabled state.
Q01SSEN? Query screen saver enabled state.
8.111. SSSTART -- Set Idle Time Required for Screen
Saver to Start
This command sets or queries the amount of time (in milliseconds) that the front panel buttons must
be idle before the screen saver starts.
This command is an integer command. See
command. The minimum and maximum values for this command are 500 and 600000, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example
Increase screen saver delay by
0.5 seconds (500 ms).
Query screen saver delay.
Description
Q01SSDELAYx , where x is the new value of
the screen saver delay. If this command was
issued after the example above, then the
status message would be Q01SSDELAY2500 .
Q01SSDELAYx , where x is the new value of
the screen saver delay. If this command was
issued after the example above, then the
status message would be Q01SSDELAY2500 .
Section 6.1 for more information on this type of
Status Message
Q01SSEN1
Q01SSEN0
Q01SSENx , where x is 0 or 1 depending on the
current enabled state of the scrren saver.
Q01SSENx , where x is 0 or 1 depending on the
current enabled state of the scrren saver.
Section 6.2 for more information on this type of
Status Message