Amprior -- Set Gating Priority For The Specified Mic; Amrefb -- Set Automixer Reference Bias For The Specified Automixer - Polycom Vortex EF2210 Program Manual

This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Set off attenuation for automixer
Q01AMOFFAT118
1 to 18 dB.
Query current off attenuation for
Q01AMOFFAT1?
automixer 1.

8.24. AMPRIOR -- Set Gating Priority for the Specified Mic

This command sets the automixer gating priority for the specified input channel. Priority levels of 1-4
are allowed with 1 being the highest priority and 4 being the lowest.
This command is a channel integer command. See
on this type of command. The minimum and maximum values for this command are 1 and 4,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Set microphone input 1 to gating
Q01AMPRIOR11
priority 1.
Query current gating priority for
Q01AMPRIOR1?
microphone input . 1.
8.25. AMREFB -- Set Automixer Reference Bias for the
Specified Automixer
This command sets or queries the reference bias for the automixer reference mode feature of the
specified automixer. When enabled, the automixer reference feature uses the AEC reference to
prevent local microphones from gating on audio from the remote side. The
controls the enabled status of this feature. The AMREFB command can be used to bias the AEC
reference signal to make the automixer even less likely to gate on remote audio.
The first argument in this command specifies the automixer number (always 1 on the EF2210) and
the second argument specifies the reference bias in dB.
Even though this is a channel integer command, use of the wildcard character for the automixer
Status Message
Q01AMOFFAT118
Q01AMOFFAT1x, where x is between 1 and
100 depending on the current setting of the
off attenuation for automixer 1.
Section 6.3 and Section 6.2
Status Message
Q01AMPRIOR11
Q01AMPRIOR1x, where x is between 1 and 4
depending on the current gating priority
setting for microphone input . 1.
for more information
command
AMREFE