Amgatec -- Set Automixer Gating Control Mode; Amgater -- Set Automixer Gate Ratio - Polycom Vortex EF2210 Program Manual

Q01AMDECAY>500
Q01AMDECAY?

8.14. AMGATEC -- Set Automixer Gating Control Mode

This command sets the automixer gating control mode for the specified input channel. The possible
modes are:
0 - normal gating
1 - microphone forced on
2 - microphone forced off
This command is a channel integer command. See
on this type of command. The minimum and maximum values for this command are 0 and 2,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Configure microphone input 1 for
Q01AMGATEC10
normal gating.
Configure microphone input 1 to be
Q01AMGATEC11
forced on.
Configure microphone input 1 to be
Q01AMGATEC12
forced off.
Query current gating control mode
Q01AMGATEC1?
for microphone input 1.

8.15. AMGATER -- Set Automixer Gate Ratio

This command sets the automixer gate ratio (in dB) for the specified input channel. The gate ratio is
the ratio of the speech power to noise power required to gate the microphone on. This value is only
used if the input is set to automatic gating via the AMAUTO.
Increase automixer decay time
by 500 ms.
Query automixer decay time.
Q01AMDECAYx, where x is between 0 and
5000 depending on the current AMDECAY
setting. If this command is issued after the
above example, then the status message will
be
Q01AMDECAYx, where x is between 0 and
5000 depending on the current AMDECAY
setting. If this command is issued after the
above example, then the status message will
be Q01AMDECAY1000
Section 6.3 and Section 6.2
Status Message
Q01AMGATEC10
Q01AMGATEC11
Q01AMGATEC12
Q01AMGATEC3x, where x is 0, 1, or 2
depending on the current gating control mode
setting for microphone input 1.
for more information