Delayo -- Set Output Delay; Delayoe -- Enable Output Delay - Polycom Vortex EF2210 Program Manual

8.37. DELAYO -- Set Output Delay

This command sets the amount of output delay (in tenths of milliseconds) on each of the three output
channels (1, A, B) . Use of the wildcard character (*) for specifying the channel is not supported for
this command. The output delay can be separately enabled or disabled via the
This command is an integer command. See
command. The minimum and maximum values for this command are 0 and 3400, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example
Q01DELAYOB1500
Q01DELAYOB>1700
Q01DELAYOB?

8.38. DELAYOE -- Enable Output Delay

This command sets or queries the enabled state of the output delay for each of the three output
channels (1, A, B) .
This command is a channel boolean command. See
on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example
Q01DELAYOEB1
Description
Set output delay on output
channel B to 150 ms (1500
tenths of milliseconds).
Increase output delay on output
channel B by 170 ms (1700
tenths of milliseconds.)
Query current output delay on
output channel B .
Description
Enable output delay on output B
.
Section 6.2 for more information on this type of
Status Message
Q01DELAYOB1500
Q01DELAYOBx , where x is between 0 and
3400 depending on the current output delay
setting for output channel B . If this
command is issued after the above example,
then the status message will be
Q01DELAYOB3200 .
Q01DELAYOBx , where x is between 0 and
3400 depending on the current output delay
setting for output channel 2. If this command
is issued after the above example, then the
status message will be Q01DELAYOB3200 .
Section 6.3 and
Status Message
Q01DELAYOEB1
DELAYOE
Section 6.1 for more information
command.