Macroa -- Add Command To Current Macro - Polycom Vortex EF2210 Program Manual

This command is a channel integer command. See
on this type of command. The minimum and maximum values for this command are 1 and 5,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Set AGC ramp rate on input
Q01LAGCRATEA3
channel A to 3 dB/sec.
Query the AGC ramp rate on
Q01LAGCRATEB?
input channel B.

8.60. MACROA -- Add Command to Current Macro

This command adds a command to the macro currently in progress. This is used in conjunction with
the and
MACROS MACROW
The syntax of this command specifies a macro number, a comma, and then the command to be
added to the macro. The command to be added to the macro can be any valid command except the
following:
any PRESET command
any MACRO command
any logic input or output command
If an attempt to assign an invalid command to a macro is made (via MACROA), then the error
condition ERROR#074 will be generated.
An error will be generated if the specified command is not a valid command. However, an error will
not be generated if the specified command is valid, but its data is invalid. For example:
Q01MACROA25,LAYDOWNTHEBOOGIE
Would return an error because it does not contain a valid command. However:
Q01MACROA62,MUTEOMYMOTHERINLAW
Would not return an error because it contains a
the macro is executed with a
command with strange data.
commands to create a new macro.
or
MACROX MACROQ
Section 6.3 and Section 6.2
Status Message
Q01LAGCRATEA3
Q01LAGCRATEBx, where x is a number
between 1 and 5, depending on the current
setting of the AGC ramp rate on input channel
B.
command. An error would be returned when
MUTEO
command and it tries to execute the
for more information
MUTEO