Peqos -- Set Slope Parameter For Specified Parametric Eq Output Stage - Polycom Vortex EF2210 Program Manual

parameter, the gain, is specified instead of all the parameters. See the
information. To set the gain parameter for an input parametric EQ filter, use the
set all the parameters for an input parametric EQ filter, use the
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example
Q01PEQOG1,2,-20
Q01PEQOGB,1,?
8.94. PEQOS -- Set Slope Parameter for Specified
Parametric EQ Output Stage
This command sets or queries the slope parameter (in dB per octave) for the parametric equalizer
(EQ) filters on output channels 1, A, and B . Each channel has five bands of parametric EQ that can
be independently controlled.
For the Linkwitz-Riley filters, the slope can either be 12 or 24 (dB/Octave).For the low shelf and high
shelf filters, the minimum value for the slope parameter is 1, and the maximum value is 1.2 times the
current value of the gain parameter. See the
This command has the same format and restrictions as the
parameter, the slope, is specified instead of all the parameters. See the
information. To set the slope parameter for an input parametric EQ filter, use the
To set all the parameters for an input parametric EQ filter, use the
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Set the slope of the parametric
EQ on output 1 , band 2 to 1 dB
Q01PEQOS1,2,1
per octave.
Description
Set the gain of the parametric
EQ on output 1 , band 2 to -20
dB.
Query current gain setting of
parametric EQ on output B ,
band 1.
PEQIA
Status Message
Q01PEQOG1,2,-20
Q01PEQOGB,1,g , where g is the current
setting of the gain parameter for the
parametric EQ on output B , band 1. If the
gain parameter of this filter is set to the
same value given in the example above,
then the status message will be
Q01PEQOGB,1,-20 .
command for information on the gain parameter.
PEQIG
PEQOA
Status Message
Q01PEQOS1,2,1
command for more
PEQOA
PEQIG
command.
command except that only one
command for more
PEQOA
PEQIS
command.
PEQIA
command. To
command.