Phantom -- Enable Phantom Power On Input; Ping -- See Which Devices Are Present - Polycom Vortex EF2210 Program Manual

Query current type setting of
parametric EQ on output B , band
Q01PEQOT1,2,1
1.

8.96. PHANTOM -- Enable Phantom Power on Input 1

This command sets or queries the status of phantom power on microphone input 1.
This command is a channel boolean command. See
on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Enable phantom power for input
Q01PHANTOM11
channel 1.
Disable phantom power for input
Q01PHANTOM10
channel 1.
Toggle phantom power state for
Q01PHANTOM12
input channel 1.
Query state of phantom power for
Q01PHANTOM1?
input channel 1.

8.97. PING -- See Which Devices Are Present

When any Vortex device receives this command, it responds with a PONG status message. This is
typically used by the host program to determine the types and IDs of all linked devices. When used in
this manner, wildcard characters are usually given for the device type and ID so that all connected
devices will respond.
In the following example, it is assumed that there are two EF2280's (device IDs 0 and 1), two
EF2241's (device IDs 2 and 3), two EF2211's (device IDs 4 and 5), two EF2210's (device ID's 6 and
7), and two EF2201's (device ID's 0 and 1) linked together via EF Bus.
Example Description
Q01PEQOTB,1,t , where t is the current
setting of the type parameter for the
parametric EQ on output B , band 1. If the
type parameter of this filter is set to the same
value given in the example above, then the
status message will be Q01PEQOTB,1,1 .
Section 6.3 and Section 6.1
Status Message
Q01PHANTOM11
Q01PHANTOM10
Q01PHANTOM1x, where x is 0 or 1 depending
on the current state of phantom power on
input channel 1.
Q01PHANTOM1x, where x is 0 or 1 depending
on the current state of phantom power on
input channel 1.
for more information
Status Message