Amlmm -- Set Last Mic On Mode For Specified Automixer - Polycom Vortex EF2210 Program Manual

This command is an integer command. See
command. The minimum and maximum values for this command are 0 and 5000, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Set automixer hold time to 500
Q01AMHOLD500
ms.
Increase automixer hold time by
Q01AMHOLD>500
500 ms.
Query automixer hold time.
Q01AMHOLD?
8.19. AMLMM -- Set Last Mic On Mode for Specified
Automixer
This command sets "last mic on" mode for the specified automixer. The first argument specifies which
automixer (always 1 on the EF2210) The second parameter specifies the operation of "last mic on"
mode and can be one of the following:
0 - last mic mode is off
1 - manual (use a specific mic)
2 - automatic (the last gated mic remains on)
Even though this is a channel integer command, use of the wildcard character for specifying the
automixer number is not supported.
This command is a channel integer command. See
on this type of command. The minimum and maximum values for this command are 0 and 2,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Section 6.2 for more information on this type of
Status Message
Q01AMHOLD500
Q01AMHOLDx, where x is between 0 and
5000 depending on the current AMHOLD
setting. If this command is issued after the
above example, then the status message will
be Q01AMHOLD1000
Q01AMHOLDx, where x is between 0 and
5000 depending on the current AMHOLD
setting. If this command is issued after the
above example, then the status message will
be Q01AMHOLD1000
Section 6.3 and
Status Message
Section 6.2 for more information