Cleaning The Mixer Feeder - PRONAR VMP-5ST Manual

SECTION 5

5.10 CLEANING THE MIXER FEEDER

The mixer feeder tank together with the auger mixer and chute shields must be cleaned after
each use and longer (several days) standstill of the mixer feeder. Other components should
be cleaned as needed. Before using pressure washer the user is obliged to acquaint himself
with the operating principles and recommendations concerning safe use of this equipment.
The mixer feeder cleaning guidelines
• Before cleaning the mixer feeder, open the tank slide gates. Carefully remove the
remains of feed from the auger mixer (for example, blow out with compressed
air).
• To wash the tank interior, the auger mixer and the chute shields, use clean
running water only; in other cases you may use water with a cleaning detergent
with neutral pH.
• Using pressure washer increases washing effectiveness, but particular care must
be taken during work. During washing, washer nozzle may not be closer than 50
cm from the surface being cleaned.
• Water temperature should not exceed 55
• Do not direct a water jet directly at system elements and equipment of the mixer
feeder i.e. control valve, braking force regulator, brake cylinders, pneumatic,
electric and hydraulic plugs, lights, electrical connections, information and
warning decals, identification plate, conduit connections and lubrication points etc.
Great water jet pressure may damage these elements.
• For cleaning and maintenance of plastic coated surfaces it is recommended to
use clean water or special preparations designed for this purpose.
• Do not apply organic solvents, preparations of unknown origin or other
substances, which may cause damage to lacquered, rubber or plastic surfaces. In
the event of doubt it is recommended to make a test on an unseen surface area.
• Surfaces smeared with oil or grease should be cleaned by application of benzene
or other degreasing agents and then washed with clean water with added
detergent. Comply with recommendations of the Manufacturer of cleaning agents.
Pronar VMP-5ST | Pronar VMP-6ST
0
C.
5.23