Preparing The Mixer Feeder For Normal Use - PRONAR VMP-5ST Manual

Pronar VMP-5ST | Pronar VMP-6ST
Test start
Make sure there are no objects or living animals in the mixer feeder tank.
Start the tractor's engine, close the dispensing window, start PTO drive. Stop
the PTO drive after 3 minutes.
Release tractor's parking brake. Perform test drive.
If during test run worrying symptoms occur such as:
• noise and abnormal sounds caused by rubbing of moving elements against the
mixer feeder structure,
• hydraulic oil leak,
• incorrect hydraulic system operation
• other suspected faults,
immediately disengage the tractor's PTO drive and turn off the tractor engine. If a fault cannot
be rectified or the repair could void the warranty, please contact retailer for additional
clarifications or to perform the repair.

4.1.4 PREPARING THE MIXER FEEDER FOR NORMAL USE

Scope of inspection activities
Visually inspect if the tyres are properly inflated. In case of doubt, carefully
check tyre pressure.
Check level of transmission lubricating oil in the expansion tank.
Check technical condition of drawbar eye.
Check technical condition and completeness of safety guards.
Check the condition of cutting blades and counter blades and their proper
mounting.
Check technical condition of PTO shaft, its shields and securing chains.
The above-mentioned activities should be performed before each start of the mixer feeder.
Detailed information on other activities, inspection intervals and related procedures are
included in section 5 MAINTENANCE.
4.4
SECTION 4