Table of Contents
Advertisement
SECTION 3
Feed batching speed depends on the auger mixer speed and the degree of opening of the
slide gate. While parking the mixer feeder, the quick coupler terminals should be protected
against contamination by placing them in special sockets on the platform. Design and
diagram of the hydraulic system is shown in figure (3.6).
3.2.5 TRANSMISSION LUBRICATION SYSTEM
FIGURE 3.7
Transmission lubrication system
(1) oil expansion tank, (2) plug, (3) supply conduit, (4) bleed conduit, (5) planetary gear
The transmission lubrication system is shown in figure (3.7). The gear oil expansion tank (1)
is located in the front section of the mixer feeder tank. Conduit (3) connects the tank with the
gear. Oil flows down to the reduction gear and supplements missing oil.
TIP
The transmission lubrication system holds 12.5 litres of oil.
Pronar VMP-5ST | Pronar VMP-6ST
3.9
Advertisement
Table of Contents
