Table of Contents
Advertisement
Pronar VMP-5ST | Pronar VMP-6ST
Checking the wheel nut tightening:
The above actions should be repeated individually if a wheel has been removed from the
wheel axle.
TABLE 5.1
Spanner arm
WHEEL TIGHTENING TORQUE
[Nm]
270
ATTENTION
Wheel nuts may not be tightened with impact wrench because of danger of exceeding
permissible tightening torque, the consequence of which may be breaking the thread
connection or breaking off the hub pin.
The greatest precision is achieved using a torque spanner. Before commencing work,
ensure that correct tightening torque value is set.
5.2.5
CHECKING AIR PRESSURE IN TYRES, EVALUATING TECHNICAL
CONDITION OF TYRES AND STEEL WHEELS
Tyre pressure should be checked each time after changing spare wheel and not less than
every month. In the event of intensive use, air pressure in tyres should be checked more
frequently. During this time the mixer feeder must be unloaded. Checking should be done
before travelling when tyres are not heated, or after an extended period of parking.
• after first use of the mixer feeder,
• after first travel with load,
• every 6 months of use.
BODY WEIGHT (F)
[kg]
90
77
67
60
5.8
SECTION 5
ARM LENGTH (L)
[m]
0.30
0.35
0.40
0.45
Advertisement
Table of Contents
