Withdrawal From Use - PRONAR VMP-5ST Manual

Pronar VMP-5ST | Pronar VMP6-ST
DANGER
Used hydraulic or gear oil or gathered remains mixed with absorbent material should be
stored in a precisely marked container. Do not use food packaging for this purpose.
While carrying out maintenance and repair work, which involves the risk of an oil leak, this
work should take place on an oil resistant floor or surface. In the event of oil leaking into the
environment, first of all contain the source of the leak, and then collect the leaked oil using
available means. Remaining oil should be collected using sorbents, or by mixing the oil with
sand, sawdust or other absorbent materials. The oil pollution, once gathered up, should be
kept in a sealed, marked, hydrocarbon resistant container. The container should be kept
away from heat sources, flammable materials and food.
TIP
The hydraulic system of the mixer feeder is filled with L-HL 32 Lotos hydraulic oil. Please
refer to Section 5 for information on transmission oil used.
Used oil or oil unsuitable for further use due to loss of its properties should be stored in its
original packaging in the conditions described above. Waste oil should be taken to the
appropriate facility dealing with the re-use of this type of waste. Waste code (L-HL 32 Lotos
hydraulic oil): 13 01 10. Detailed information concerning hydraulic oil may be found on the
product's Material Safety Data Sheet.
ATTENTION
Waste oil should only be taken to the appropriate facility dealing with the re-use of this
type of waste. Do NOT throw or pour oil into sewerage or water tanks.

1.7 WITHDRAWAL FROM USE

In the event of decision by the user to withdraw the mixer feeder from use, comply with the
regulations in force in the given country concerning withdrawal from use and recycling of
machines withdrawn from use. Before proceeding to dismantle equipment oil shall be
completely removed from hydraulic system and gearbox.
1.12
SECTION 1