Preparing The Mixer Feeder For The First Use, Test - PRONAR VMP-5ST Manual

SECTION 4
Ensure that the attached PTO shaft may be connected to the tractor, check
rotation direction of tractor PTO.
If non-conformities are found, do not attach and start the mixer feeder. Discovered defects
should be notified directly to the seller in order to remove them.
ATTENTION
The seller is obliged to conduct the first start up of the mixer feeder in the presence of the
user.
The user trained by the seller is not released from the obligation to read this operator's
manual carefully.
4.1.3 PREPARING THE MIXER FEEDER FOR THE FIRST USE, TEST RUN OF
THE MIXER FEEDER
TIP
Operating activities: hitching to/unhitching from tractor, etc. are described in detail in
further sections of the Operator's Manual.
Preparing for the test run
Carefully read this OPERATOR'S MANUAL , the operator's manual of the
PTO shaft and the operator's manual of the scales and adhere to the
recommendations contained in these documents.
Visually inspect the mixer feeder according to the guidelines presented in
section PREPARING THE MIXER FEEDER FOR NORMAL USE.
Hitch the mixer feeder to tractor according to the guidelines presented in
section 4.2. Make certain that the PTO rotation direction is correct. Immobilise
the tractor with parking brake.
Check oil level in the drive transmission and in the expansion tank of the
transmission lubrication system.
Adjust the height and position of the scales display.
Pronar VMP-5ST | Pronar VMP-6ST
4.3