Table of Contents
Advertisement
Pronar VMP-5ST | Pronar VMP-6ST
4.1 PREPARING THE MIXER FEEDER FOR NORMAL USE
4.1.1 PRELIMINARY INFORMATION
The mixer feeder is supplied to the user completely assembled and does not require
additional assembling of the machine sub-assemblies. The manufacturer guarantees that the
machine is fully operational and has been checked according to quality control procedures
and is ready for use. This does not release the user from an obligation to check the
machine's condition prior to purchasing and before first use.
4.1.2 HAND-OVER AND INSPECTION OF THE MACHINE AFTER DELIVERY
After delivery of the machine to the buyer, the user is obliged to check technical condition of
the mixer feeder (one-time inspection). While buying the machine, the user must be informed
by the seller about the method of use of the mixer feeder, risks resulting from the use for
purposes other than intended, the method of the machine hitching and the principles of the
machine construction and design. Detailed information concerning the machine hand-over
are included in the WARRANTY BOOK.
Checking the mixer feeder after delivery
Check completeness of the mixer feeder according to order.
Check components of the scales system.
Check technical condition of safety guards.
Check condition of paint coating; check the machine for traces of corrosion.
Check the machine for damage resulting from wrong transport of the machine
to its destination (crushing, piercing, bending or breaking of minor elements
etc.).
Check technical condition of PTO shafts and their shields as well as
completeness of these elements.
Check technical condition and mounting of the blades on the auger and the
counter blades installed in the tank.
Check air pressure in tyres and check correct tightening of wheel nuts.
Check technical condition of drawbar eye and if correctly installed.
4.2
SECTION 4
Advertisement
Table of Contents
