Table of Contents
Advertisement
Pronar VMP-5ST | Pronar VMP-6ST
depends also on the material mixed in the tank - its size, humidity, etc. The counter blades do
not require sharpening.
ATTENTION
The counter blades may be adjusted only when the auger mixer is not rotating.
4.7 CLEANING
Remove the remains of feed from the mixer feeder after finished feed dispensing. It is
recommended to do this using a pressure washer. In order to do this:
open both dispensing slide gates,
turn off the tractor engine and remove key from ignition.
immobilise tractor with parking brake,
clean the mixer feeder with a strong water jet and leave it to dry.
In winter, the mixer feeder drying should be performed in a room with a temperature above 0
C. Frozen water may cause damage to paint coating or machine components. Non-
observance of the recommendations concerning the mixer feeder cleaning creates a real risk
of growth of bacteria that may cause animal diseases.
ATTENTION
Clean the machine thoroughly again if it has not been used for more than three days.
Remove the remains of feed from the mixer feeder each time after finished work.
4.8 PROPER USE AND MAINTENANCE OF TYRES
• When mounting and dismounting tyres, the mixer feeder must be immobilized by
means of 2 chocks placed under the wheels.
• Repair or replacement of tyres should be carried out by persons trained and
entitled to do so using appropriate devices and tools.
4.14
SECTION 4
o
Advertisement
Table of Contents
