SECTION 3
Pronar VMP-5ST | Pronar VMP-6ST
3.2.3 DRIVE TRANSMISSION
The power driving the auger mixer is transmitted from the tractor through the PTO shaft (6)
connecting the mixer feeder with the tractor and the intermediate shaft (2) with friction
overload clutch to the reduction planetary gear (1). The auger mixer (3) is mounted on the
gear output shaft.
FIGURE 3.5
Drive transmission
(1) planetary gear, (2) intermediate drive shaft, (3) auger mixer, (4) shaft terminal cover, (5)
shaft connector, (6) drive shaft
3.2.4 HYDRAULIC SYSTEM OF THE SLIDE GATES
The slide gate control system is supplied from the external hydraulic system of the tractor.
This solution makes it possible to batch feed on the right side of the mixer feeder and unload
feed to the rear in the centre of the feed corridor.
3.7