Nat Configuration; View Network Status; Basic Configuration; General Configuration - Speco N8NRN User Manual

Device Management
Protocol type and EAPOL version: Please use the default settings.
User name and password: The user name and password must be the same with the user name and password applied for and registered in the
authentication server.

13.1.8 NAT Configuration

Click Start Settings Network NAT to go to the interface for NAT configuration and check "Enable". Click "Apply" to save the settings and make
note of the QR code number under the QR code. Via Internet Explorer, go to connect.specotech.cloud, input the QR code number, your username
and password to login.
You can also scan the QRcode through Speco Blue App which is installed in the mobile phone or tablet to log in the mobile client instantly.

13.1.9 View Network Status

Click Start Settings Network
network status conveniently.

13.2 Basic Configuration

13.2.1 General Configuration

Click Start Settings System Basic General Settings to go to the following interface. Set the device name, device No., language, video format
and main output. Enable or disable wizard, "Log in Automatically", "Log Out Automatically" (if checked, you can set the wait time), "App Live
Self-Adaption" and "Dwell Automatically" (if checked, you can set the wait time). Click "Apply" to save the settings.
Device Name: The name of the device. It may display on the client end or CMS that help user to recognize the device remotely.
Video Format: Two modes: PAL and NTSC. Select the video format according to the camera.
Sequence Automatically: Check it and set "wait time". The system will sequence automatically if it is not operated during the time you set.

13.2.2 Date and Time Configuration

Click Start Settings System Basic Date and Time to go to the interface as shown below.
Set the system time, date format, time format and time zone of the NVR. The default time zone is GMT+08 Beijing, Hong Kong, Shanghai, Taipei. If
the selected time zone includes DST, the DST of the time zone will be checked by default. Click "Apply" to save the settings.
You can manually set the system time or synchronize system time with network through NTP.
Status to view the network status or click on the tool bar at the bottom of the live view interface to view
80
NVR User Manual